Table of Contents
Advertisement
Black level (master pedestal) adjustment
The black level can be adjusted when using a multiple number of
cameras including the unit. Ask your dealer to perform this adjustment.
(Use an oscilloscope or waveform monitor for the adjustment.)
Adjust the black level in accordance with the units and devices used.
When performing operations from a wireless
remote control
1.
Press the <M/IRIS> button.
Set the iris to the manual mode.
2.
Press the <IRIS –> button.
The lens iris is stopped down.
3.
Press the <4> or <5> button to bring the cursor to
[Picture].
4.
Press the <M> button.
The [Picture 1/3] sub-menu is displayed.
Pic tur e 1/ 3
Ch roma Lev el
Wh ite B ala nc e M od e
C olor Tem pe ra t ur e
R Gain
B Gain
Pe desta l
R Pede sta l
B Pede sta l
Re turn
5.
Press the <4> or <5> button to bring the cursor to
[Pedestal].
Pic tur e 1/ 3
Ch roma Lev el
Wh ite B ala nc e M od e
C olor Tem pe ra t ur e
R Gain
B Gain
Pe desta l
R Pede sta l
B Pede sta l
Re turn
6.
Press the <M> button to start the [Pedestal] value
blinking.
7.
Press the <4> or <5> button, change the [Pedestal]
value, and press the <M> button to enter the selection.
Adjust the value so that it matches the black level.
The pedestal values can be adjusted finely using the [R Pedestal] and
[B Pedestal] settings. (→ page 46, page 76)
8.
Press and hold the <MENU> button for about 2 seconds.
The camera menu display is exited.
9.
If necessary, press the <A/IRIS> button to adjust the iris
automatically.
When performing operations from a controller
When using an AW‑RP50, AW‑RP120, or AK‑HRP200
Refer to the operating instructions for the controller.
0 %
AW B A
32 00 K
0
0
0
0
0
0 %
AW B A
32 00 K
0
0
0
0
0
Black level
32
Advertisement
Table of Contents
