Pr Level Adjustment; Pb Level Adjustment - Panasonic AJ-D610WBP Service Manual

3-5. PR Level Adjustment

BOARD ENCODER
TP P1-B52 PIN (PR_26P)
VR3
ADJUST
SW201, SW1
MODE CAMERA BAR
M. EQ. WFM Monitor
NTSC A = 700mV+/-14mV
SPEC.
PAL A = 525mV+/-10mV
1. Connect a 26P connector to other VCR.
2. Confirm the SW201 (26P) is ON.
Menu Setting
3. Set [MENU] switch to SET while pressing [SHIFT],
[+], and [-] buttons on the operation panel.
4. Set the menu as shown below.
PAGE : MAIN MENU 1/4
KNEE LEVEL
ITEM : SET UP 25/50
5. Adjust VR3 so that the Level A at P1-B52 is in the
specification.
<NTSC>
<Note>
Confirm both SW1-1 and SW1-2 is at S side.
<PAL>
<Note>
Confirm both SW1-1 and SW1-2 is at M side.
1. Connect a 26P connector to other VCR.
2. Confirm the SW201 (26P) is ON.
Menu Setting
3. Set [MENU] switch to SET while pressing [SHIFT],
4. Set the menu as shown below.
: 7.5% (NTSC)
5. Adjust VR4 so that the Level A at P1-A48 is in the
<NTSC>
A
<Note>
<PAL>
<Note>
ELE- 13

3-6. PB Level Adjustment

BOARD ENCODER
TP P1-A48 PIN (PB_26P)
VR4
ADJUST
SW201, SW1
MODE CAMERA BAR
M. EQ. WFM Monitor
NTSC A = 700mV+/-14mV
SPEC.
PAL A = 525mV+/-10mV
[+], and [-] buttons on the operation panel.
PAGE : MAIN MENU 1/4
KNEE LEVEL
ITEM : SET UP 25/50
specification.
Confirm both SW1-1 and SW1-2 is at S side.
Confirm both SW1-1 and SW1-2 is at M side.
: 7.5% (NTSC)
A