Entrust SR200 Sdk Manual page 76

Error Code
No.
SK ASC ASQ
50 05 20 00
51 05 24 00
53 05 26 00
54 05 27 00
55 05 2A 00
56 05 2B 00
57 05 2C 00
58 05 2D 00
59 05 FB 00
60 06 28 00
61 06 29 00
62 42 A2 00
63 42 B2 00
64 04 C2 00
65 03 A8 00
66 05 2E 00
67 05 21 00
68 05 23 00
69 05 22 00
70 04 C3 00
71 03 95 00
Name
Invalid Command
Operation Code
Illegal Field in CDB
Invalid Field in
Parameter List
Invalid Color Code in
CDB
Command Sequence
Error
MG Data Error
IC Encoder not
installed
MG Encoder not The printer does not have a magnetic stripe
installed unit but that function was requested for the
card.
Invalid Download
Data
Medium Changed
Power On or Bus
Device Reset
Occurred
Media Run Out
Ink Run Out
HR Overheat
MG Write Error in
Self Test
Option Not Installed
Security Key is
already set
Security key is not set
Invalid Security Key
Detect Power
Interrupt
Jam(Retransfer)
SR200 & SR300 Printer SDK Guide
Contents
The content of the command is not valid.
Operation Code in CDB is not valid.
The content of the command is not valid.
The data in CDB is not valid.
The content of the command is not valid.
The data in Page Data is not valid.
The ink specified is not valid.
The command is issued out of order.
For example, the Load Card command is
issued when a card is in the printer.
Magnetic stripe data from the PC does not
meet requirements.
The printer does not have a smart card (IC)
unit but that function was requested for the
card.
Data download from the PC is not valid.
The printer was initialized by pressing the
RESET button.
The printer was initialized by turning on the
printer power.
The end of the retransfer film is detected.
The end of the ink ribbon is detected.
The temperature of the bend remedy heat
roller or retransfer heat roller.
MG writing error happens in MG Self Test.
The command could not be executed as the
turn over unit is not attached.
New security key could not be registered as
the key is already set.
Security key is not registered.
Security key is invalid.
24V electric power was interrupted.
Card JAM error happens during retransfer.
Page 71