Card Move Function - Entrust SR200 Sdk Manual

Card Move Function

No. Function Name
1 int CXCMD_MoveCard
(int iSlot, int iID,
int iDest,
int iFlip,
int iFilmInit,
int iImmed)
Tips for success
♦
If the retransfer film is printed on but not used, set iFilmInit to 1 to move the
printed area of the retransfer film.
♦
The driver returns an error if CXCMD_LoadCard() is used when there is no
card in the printer.
♦
The driver returns a positive value if CXCMD_LoadCard() is issued while the
printer is moving a card or the retransfer film. See
Functions
♦
If the function returns a positive value, wait and retry the function.
Explanation
Move a card (after it is picked) to the specified position.
iDest Destination to move card.
0 Retransfer position
1 Contact IC encoder
2 No-contact IC encoder
3 MG encoder
4 NG Card outlet. Discharges the card from NG card
outlet (on the right side of the printer).
iFlip Specify whether turn over the card.
0 Do not turn the card over
1 Turn over the card before arriving at the destination
iFilmInit Specify whether to move the retransfer film. This
setting is effective only when iDest is 4 (NG Card outlet).
0 Not adjusted
1 Adjusted
iImmed The immediate flag specifies when the printer
replies.
0 Reply after printer finishes printing.
1 Reply immediately after printer accepts the command.
for return values.
SR200 & SR300 Printer SDK Guide
Return Codes from
Page 14