Entrust SR200 Sdk Manual page 75

Error Code
No.
SK ASC ASQ
31 04 AC 00
36 04 BF 00
38 04 C1 00
39 04 D8 00
40 04 F0 00
41 04 F1 00
42 04 F2 00
43 04 F3 00
44 04 F4 00
45 04 F5 00
46 04 F6 00
47 04 F8 00
49 05 1A 00
Name
MG Hardware
EXT2. Communicate
Heater Cam
Hardware
TR Overheat
TR Broken
TR Sensor Broken
RR Overheat
RR Broken
RR Sensor Broken
Overcool
Head Overheat
Parameter List
Length Error
SR200 & SR300 Printer SDK Guide
Content
A hardware error occurred in the
magnetic stripe unit.
A communication error occurred during
the laminator firmware update.
The heater cam is out of order.
Circuit trouble was detected at
initialization or writing error to the
laminator memory fails during the
firmware update.
For example, the power supply unit is not
delivering the needed level of power.
The temperature of the retransfer roller is
too hot.
The retransfer roller is out of order.
The retransfer roller thermister is out of
order.
The temperature of the bend remedy
roller is too hot.
The bend remedy roller is out of order.
The bend remedy roller thermistor is out
of order.
The temperature in the printer is too cool.
The temperature of the thermal head is
too hot.
The content of the command is not valid.
Parameter list length value in CDB or
Page Data is not valid.
Page 70