Process Flow To Issue The Card - Entrust SR200 Sdk Manual

Process Flow to Issue the Card

First, use the Scan Printer function to obtain the Slot number and ID of the printer.
When you have these values, you can use them to send commands to the printer.
The following diagram shows the typical flow for card processing.
Scan Printer
You can use a different order if needed by your card design.
Image Out
Card Load *
Print *
IC Control
Card Move
MG Writing
Card Move
Retransfer & Turn *
Image Out
Print
Retransfer & Eject
SR200 & SR300 Printer SDK Guide
Commands marked * should set
the Immediate flag to On so
mechanical and data actions
happen in parallel. With
Immediate set to On, the
command ends after the
command is accepted by the
printer so the software can take
the next action, such as sending
the image.
Each group of items inside a
dashed-line box is optional.
The diagram shows some but
not all card positioning
commands. You must position
the card at the correct location
for each command.
If errors occur before Retransfer
and Eject, the card is
discharged from the Reject
Card Slot. Only the Retransfer
command ejects the card to the
card stacker (or laminator, if
used).
Page 5