Led Description - ICP DAS USA DN-8368MB User Manual

1.5 LED Description

LED is used for indicating a specific or emergent DI state, there are two types of
LED indicator on the daughter board, one is for showing machine I/O state (Home,
LMT-, LMT+, RDY, etc.), the other is for showing Power and EMG state. The detail
descriptions are as follows:
HOME:
It shows the original signal of motion control on the machine. The
LED will be turned on when the motion control is moved to the original signal.
LMT -:
It shows the minus end-limit signal of motion control on the machine.
The minus end-limit signal of motion axis is to decide the end point of minus
moving. If this signal is on, the LED will be turned on. (This is the case when
"Normal Open" mode is set, for "Normal Close" mode, the LED is turned off
when signal is on.)
LMT +:
It shows the plus end-limit signal of motion control on the machine.
The plus end-limit signal of motion axis is to decide the end point of plus
moving. If this signal is on, the LED will be turned on. (This is the case when
"Normal Open" mode is set, for "Normal Close" mode, the LED is turned off
when signal is on.)
RDY:
It point out whether the servo motor is in the state ready for operation.
The LED will be turned on when the motor is ready
Power:
It shows the power state of DN-8368GB. The LED will be turned on
when the power is inputted.
EMG:
It shows the state of EMG signal. The LED will be turned on when the
EMG signal is triggered
http://www.icpdas.com
DN-8368MB User Manual
V 1.0 20