Table of Contents
Advertisement
JP7
This Jumper is used for setting each axis EMG signal when the SW1 is set to ON, it
connects to EGND directly or connects to EMG/GDI11 by user wiring. The detail
content is as below (Fig. 1-7 or Fig. 1-8):
Fig 1-7 The EMG signal is connected to E_GND, directly. (Default setting)
Fig 1-8 the EMG signal is used by EMG/DI11
JP8 ~ JP9
This jumper (JP8 ~ JP9) is used for choosing the RS232 of the computer connect
with any axis of DN-8368MB of J2S servo-driver. And they (JP8 and JP9) must be
set at the same time. The detail content is as below (Fig. 1-9):
Fig 1-9 with what axis link set up RS232 (Default setting is for 0/3-axis)
http://www.icpdas.com
DN-8368MB User Manual
V 1.0 17
Advertisement
Table of Contents
