4. INSTALLATION
4.1
Installation Procedures
4.1.1 Wall Mount Procedure
•
Verify that the SDRX-43-BTF and mounting hole are in good condition
•
Place the SDRX-43-BTF mounting template up against the wall and mark of mount holes
•
Mount the SDRX-43-BTF to wall use the six (6) mounting hole on the wall mount bracket
•
Connect the GND cable
Connect the Antenna cable
•
Connect the Power cable
•
Mount bracket
4.2
Grounding
Install the ground cable that is included in the package at the side of the repeater as show in the figure
•
below.
The grounding terminal is located at lower right-hand side of the BDA. The grounding cable should be
•
properly connected before powering on the equipment.
Ground terminals located on the side consisted of a 16mm²(6AWG) and should be permanently connected
•
to earth (Protective earthing conductor).
Advanced RF Technologies, Inc.
Figure 4-1
Wall Mount
Figure 4-2
Ground Cable Connection
20