Table of Contents
Advertisement
5. WEB-GUI SETUP
The Web-GUI allows the user to communicate with the repeater either locally or remotely. To connect to
the repeater locally, you will need a laptop with an Ethernet port and a RJ-45 crossover cable. To connect to
the repeater remotely, you will need to have an active internet connection and the repeater must have either
an external modem box connected to the repeater.
5.1
Repeater/PC Connection Using Web-GUI
Verify that your Local Area Connection is set to Obtain an IP address automatically under the Internet
•
Protocol (TCP/IP) properties
-
If you are connecting to the unit remotely (use of a modem), then skip steps above.
•
Connect the RJ-45 crossover cable between the laptop's Ethernet port and the repeater's Ethernet port
•
Launch an Internet Browser
•
Type the following IP address into the address bar of Microsoft Internet Explorer:
-
If you are connecting to the unit remotely, then type the IP address of the modem to connect to the
unit
The following login screen will appear:
•
If you are not the Administrator, please type in your assigned username & password which you should
have received from the Administrator.
The default username and password for the General User is
The default Administrator login is
Advanced RF Technologies, Inc.
Figure 5-1
Login page
admin
& admin, respectively.
http://192.168.63.1
adrf
& adrf, respectively.
23
Advertisement
Table of Contents
