Table of Contents
Advertisement
Host Mode
This mode should be selected only if a Duo-i6525 is used alone without being
connected to a collocated Sprint Nextel CDMA repeater functioning as a host.
Remote Mode
This mode should be selected if a Sprint Nextel CDMA repeater is being
installed along with aDuo-i6525 and the ethernet port is being used for
communicating with the CDMA repeater. In this case, a Duo-i6525 works as a
remote sending its information to the collocated Host CDMA repeater.
2.5. Installation
2.5.1. Tools
No special tools or equipments are needed in installing the Duo-i6525.
2.5.2. Procedure
Four mounting holes are provided on the wall-mounting bracket to attach it to
the wall. The wall bracket must be securely attached to sufficiently carry the
weight of the Duo-i6525, which is bolted to the wall bracket through four
aligned mounting holes.
The following steps should be followed while mounting the repeater:
Installation Procedure
① Take the Duo-i6525 out of the box
② Detach the mounting bracket from the Duo-i6525 by unscrewing the 8
screws on the bracket. ( 4 on each side)
③ Using the four guard screws, mount the bracket on the wall
④ Make sure the bracket is securely mounted
⑤ Slightly tilt the repeater and mount the repeater onto the wall as shown in
the picture. Hook the upper 2 guard screws first and then slide/push in the
lower 2 guard screws into the place.
⑥ Make sure the repeater is securely placed onto the wall bracket
⑦ Fasten the 8 bracket screws back properly
⑧ Inspect everything is secure
Advanced RF Technologies, Inc. Proprietary Document
Duo-i6525 RF Repeater
User Manual V1.0
Page 14 of 31
Advertisement
Table of Contents
