Table of Contents
Advertisement
body within the area. (This assumes a typical wide beam type antenna with gain of 0-2 dBi, VSWR ≤ 2:1, Zo= 50
ohms, and a cable attenuation of between 1-10 dB).
5. INSTALLATION
DO NOT APPLY A.C. POWER TO THE BDA UNTIL CABLES ARE CONNECTED TO BOTH PORTS OF
THE BDA AND THE ANTENNAS.
1. To mount on a wall. Using appropriate screws and anchors, attach the BDA to the wall at the four mounting
holes
2. Ensure that the isolation between the donor antenna and the service antenna is at least 15 dB greater than
the BDA gain.
3.
Connect the cable from the donor antenna to the BDA connector labeled "DONOR" and the cable from the
service antennas to the BDA connector labeled "SERVER".
4. Connect the AC power cord to the BDA and turn on the switch at the left-hand of PSU.
5. Installation of the equipment is now complete. Adjust the gain controls to suit the specific signal
environment through GUI on your PC.
-
To prevent feedback, the donor and server antennas must be separated by an appropriate distance to
provide sufficient isolation. Isolation is attained by separating antennas a sufficient distance so that the
output of one antenna does not reach the input of the other. This distance is dependent on the gain of the
repeater.
-
Prior to equipment use the service must be registered with the FCC. This can be done through the FCC's
website at https://signalboosters.fcc.gov/signal-boosters)
6. DEFAULT ITEMS
Coupling device
7. SPECIFICATIONS
Advanced RF Technologies, Inc.
Items
Antenna
Cable
Model name
17
Hide quick links:
Advertisement
Table of Contents
