Installation; Wall Mount Procedure - ADRF PSR78 User Manual

3.5 Installation

3.5.1 Wall Mount Procedure

The wall-mounting bracket has six mounting holes which are used to mount the bracket to the wall. The wall
bracket must be securely attached to the wall in order to support the weight of the PSR78. After mounting the
bracket to the wall, the PSR78 is placed on the mounting bracket using the four guard screws attached to the
PSR78.
The following steps should be followed while mounting the repeater:
① Take the PSR78 out of the box.
② Using the six anchor bolts, mount the bracket on the wall.
③ Make sure the bracket is securely mounted.
④ Slightly tilt the top portion of the repeater and mount the repeater onto the wall as shown in figure 4 in
the illustrations below. Hook the upper 2 guard screws first and then slide/push in the lower 2
guard screws into place.
⑤ Make sure the PSR78 is securely placed onto the wall bracket.
⑥ Fasten the 8 bracket screws back properly on both sides.
⑦ Verify that the repeater is secure and properly grounded.
Figure 7: Wall Mount Instructions
PSR78 Repeater
User Manual V0.1
Page | 14