Snmp Trap; Gain Control; Figure 5-12 Pop-Up Message When Reboot Button Is Pressed; Figure 5-13 Pop-Up Message When Factory Setting Button Is Pressed - ADRF SDRX-43-BTF User Manual

Click OK to reboot the repeater or click Cancel to exit out
Factory Setting: Resets the repeater to the original factory settings
•

Figure 5-13 Pop-up message when Factory Setting button is pressed

5.3.3 SNMP Trap

• SNMP Trap ON – Enables or Disables SNMP traps from being sent out when an alarm is triggered.
• Heartbeat Periodic Time [min] – Specifies the amount time between heartbeats

5.3.4 Gain Control

Downlink Gain/Uplink Gain: Allows the UL gain to be adjusted manually when ALC is OFF
•
DL Output ALC Level: Prevents the output power from exceeding the specified value
•
DL Output ALC Offset: When the incoming signal level increases, the system will not adjust the
•
attenuation levels until the delta reaches the level specified
• DL /UL Gain Balance ON: Allows the user to enable or disable the gain balance. When gain balance is
enabled, the delta value between the downlink and uplink gains remain constant
Advanced RF Technologies, Inc.

Figure 5-12 Pop-up message when Reboot button is pressed

Figure 5-14 SNMP Trap

Figure 5-15 Gain Control Setting

28