Installation; Installation Procedures; Wall Mount Procedure; Grounding - ADRF SDR-ICS-43 User Manual

4. INSTALLATION

4.1

Installation Procedures

4.1.1 Wall Mount Procedure

·
Verify that the SDR-ICS-43 and mounting hole are in good condition
·
Place the SDR-ICS-43 mounting template up against the wall and mark of mount holes
·
Mount the SDR-ICS-43 to wall use the six (6) mounting hole on the wall mount bracket
·
Connect the GND cable
·
Connect the Antenna cable
·
Connect the Power cable
Mount bracket
4.2

Grounding

·
Install the ground cable that is included in the package at the side of the repeater as show in the figure below.
·
The grounding terminal is located at lower right-hand side of the BDA. The grounding cable should be
properly connected before powering on the equipment.
·
Ground terminals located on the side consisted of a 16mm²(6AWG) and should be permanently connected to
earth(Protective earthing conductor).
Advanced RF Technologies, Inc.
Figure 4-1 SDR-ICS-43 Wall Mount
Figure 4-2 Ground Cable Connection
20