Table of Contents
Advertisement
Available languages
Available languages
s.r.l.
s.r.l.
s.r.l.
s.r.l.
6.5.4 Alarm Log
Alarm Log contains the last 50 alarms detected by the controller. Each new alarm higher than this number will take automatically
the place of the oldest memorized alarm. The display is ordered from oldest (01) to newest (50).
To read log list proceed as following:
Enter the
1.
"FUNCTION MENU" (Push
2.
Select "ALOG" function using
3.
Push
button for display Alarm Log:
-
-
-
4.
Exit by using
Note: Alarm Log can be erased only with password.
6.6 PROGRAMMING
The controller's parameters are collected into aggregates, each identified by a label. This allows the user an easy access to the
interested parameters. The label is shown on the display.
On table 6.6.2 are indicated and described all labels and correspondent programming parameters.
6.6.1 Enter the PARAMETER MENU and modification of the operation parameters
To ENTER the "parameter menu" proceed as follows:
1.
Push simultaneously for a few seconds
display will show the label of the first parameter family that can be entered.
2.
To scroll the available parameters family list use
3.
Push
button to show the parameter list contained into the chosen family: lower display will show alternately the
selected family label and the code of the first parameter, while upper display shows the value of the same parameter.
4.
To scroll the parameters contained into the selected family use
5.
Push
to activate the MODIFICATION of the displayed parameter value.
6.
Increase or decrease the parameter value using
7.
Push
button to save the new value. In the end of the memorize procedure the controller automatically goes on with
the parameter list showing the code of the next parameter.
8.
Push
button to return at previous menu.
9.
To Exit menu push simultaneously
NOTE: A new adjusted value is also memorized if exit of the parameter menu is automatic without pushing the
confirmation
button.
The CF parameter family can only be modified in stand-by mode (display shows OFF)
6.6.2 Family Label table
Contained
LABEL
Parameters
ALL
ALL
Shows all
parameters
ST01
ST
ST02
Thermoregulation
ST05
parameters
ST06
25/89
button)
and
.
Lower display will show the code of an alarm.
Upper display will show the progressive number of the same alarm.
Scroll all alarms using
button or wait for automatical exit.
Summer Set Point
Summer differential
Minimum summer set point
Maximum summer set point
Cod. 710.0103.01.01 – Rev.04 – 09.2012
and
button.
buttons. The LEDs marked with
and
buttons .
and
and
buttons.
buttons or wait 4 minutes without pushing any button (Automatic exit).
Parameters Description
ED – DXL AL
ED
ED
ED
and
start to blink, the upper
buttons .
udm
° C
° C
° C
° C
serie
STANDAR
D
Value
-1,5
6
-1,5
+1
Advertisement
Table of Contents
