How To Use This Manual; Symbols; Warranty; Description - omi ED Series Instruction Manual

s.r.l. s.r.l.
s.r.l. s.r.l.
1.0 GENERAL

1.1 How to use this manual

All features of this machine, all information on safety, machine installation, operation, adjustment and maintenance are described in this manual.
This manual is part of the machine and should be read accurately and understood by any person operating and maintaining this machine. If the
manual gets lost, please ask your dealer for a new copy.

1.2 Symbols

Air inlet
Air outlet

1.3 Warranty

This product is supplied after being regularly tested. The warranty applies if contract and administrative rules are fulfilled. Installation and use of the
machine have to comply with instructions of this manual. The manufacturer agrees in fixing or replacing all parts proved to be worn and faulty at the
factory free of charge. Final decision is left to our technicians.

1.4 Description

The refrigerant dryers in this range have been developed in order to eliminate all humidity contained in compressed air. The air temperature will be
cooled off upon +3° C cost-effectively. These dryers use Freon-coolant.
The air is practically without humidity, while all condensate that is accumulated in the condensate separator is discharged to the outside through an
electronic programmable discharger. A system overload exceeding the maximum operative limits can worsen the operational performances of the
dryer (high dew point) but will not affect its safety. The electric diagram (appendix B) shows the minimum protection degree IP 42.
ATTENTION: The machine is equipped with a power supply - sectioning device (1S1).
The installer has to take care of the dryer's correct connection to the power system, according to the
EN60204 regulation, Chapter 5.3.2.
A start and stop device (ON/OFF) allows the dryer to be turned on and working normally.
An amperometrical and a thermometrical protection (an automatic re-establishment on the compressor) prevents from electric and frigorific circuit's
damages.

2.0 SAFETY INFORMATION

2.1 General safety instructions

SAFETY INFORMATION
This dryer has been designed and manufactured in accordance to the European safety directive
98/37/CE Machine Directive
73/23/CEE Low Tension Directive
89/336/CEE Electromagnetical Compatibility Directive
97/23/CE PED Directive
According to PED Directive, this plant is supplied with safety devices on the frigorific circuit, calibrated according to the under mentioned
specifications.
The working life of such equipment is expected between 10 and 20 years.
Any installation, use and maintenance operation has to be done according to the instructions contained in this manual and the national
rules.
Any cleaning/maintenance operation which needs access to the dryer must be carried out by qualified and export personnel who must be
aware of all necessary precautions.
The machine has been designed and manufactured to be used in conformity to the following specifications.
In case of different use of the machine or not in conformity to this manual, the Manufacturer can't be accused of any responsibility.
17/89
- GB -
- Turn main power switch on position 1.
- Push the ON/OFF button.
- Wait for 8 hours before starting the dryer.
Cod. 710.0103.01.01 – Rev.04 – 09.2012
Condensate drain outlet
Electric shock danger!
ED – DXL AL ED ED ED
serie