System Setup - Gainscha GA-2408T Series User Manual

Reserve Blank: Set whether to leave blank at the end of continuous paper printing.
Select "Yes" to stop printing the content. Select "No" to leave a blank
after printing the content.
Blank Length(mm): Set the length of blank content at the end of continuous paper
printing
Cut Number: Set the number of consecutive labels reserved after cutting. If the number
is set to 1, each label is cut once. If the number is set to "N", cut every N labels.
It needs to be used together with the specified cut number in the Cut Action.
Cut Action: Set the working mode of cutting action (Cut Every Label, Cut By Cut Number,
Cut Only Last One). When selecting "Cut Every Label" each cutting, each
printed label will be cut once; When selecting "Cut By Cut Number"，it is
necessary to cooperate with cut number to use together; When choosing
"Cut Only Last One", cut once after printing.
Back After Cut: Set whether to pull back the label after cutting
Cut Mode: Select the cutting mode (Forward, Backward). If select "Forward", the paper
will be completely cut off, if select "Backward", the middle of the paper will retain a little
connection.

5.4 System Setup

This function can be used to modify the simulation language of the printer. The
simulation language can be automatically and manually selected. After the selection is
completed, click the "Set" to set the current selection. Please refer to following figure
5.4:
5.4
41