Set Access Password; Set Kill Password - Gainscha GA-2408T Series User Manual

3.1 Set Access Password

Method one: Set the Access Password in BarTender
Open BarTender and add the RFID tag
5)
Chapter 6, Section
Access password box will change from dark to light. Enter Access
Password in the input box and click "Apply" or "OK" below
Method Two: Set Access Password in PrinterUtility

3.2 Set Kill Password

Method 1: Set Kill Password in BarTender
Method Two: Set Kill Password in PrinterUtility
Appendix A for details of returned error code.
After adding the RFID tag, open the RFID option
6). In EPC Gen 2, select an area to lock and the
Click the "Access Password Setupet" in PrinterUtility
RFID Test plate for setting
plate can be seen in Section 8 of Chapter
access password to be written in the input box of
"Access Pwd.", and then click the "Write" button,
return error code details can be seen in Appendix A.
Open BarTender and add the RFID tag
in Chapter 6, Section
option (details are described in Chapter 6, Section
2, check the button to change the Kill password and enter the Kill
password in the password box. Click "Apply" or "OK" below. After
the Kill command is executed, labels die permanently and cannot
be used any more. Labels that are not configured with the Kill
Password cannot be killed.
It can be set in the Kill Password Setup area of PrinterUtility
RFID Test plate
referred to in Section 8 of Chapter
password to be written in the input box of Access Pwd., then
click the "Write" button on the lower right corner.
(Detailed in Chapter 6, Section
5). After adding the RFID tag, open the RFID
(detailed explanation of the plate can be
71
(Detailed in
(Detailed explanation of the
5), enter the
(the details are described
6). In EPC Gen
5). Enter the Access
Refer to