Ethernet; Wi-Fi; Printer Utility - Rfid Test; Write Data - Gainscha GA-2408T Series User Manual

PIN of the device that communicates with the printer and the type of data that the
device sends, and set the baud rate to the same as that of the printer.

3. Ethernet

The maximum transmission rate is the same as that of Serial port (RS232) and WIFI port.
The printer can be connected to the LAN. When the IP address of the printer does not
conflict with the IP address of other devices, other devices can search the printer
through the network, and other devices can communicate with the printer on the LAN.

4. Wi-Fi

The maximum transmission rate is the same as that of Serial port (RS232) and Ethernet
port. In this port, the printer is used as the communication end to connect to other
routing WIFI (STA mode). Under the condition that IP addresses do not conflict, other
devices in the LAN can communicate with the printer.
5.17 Printer Utility – RFID Test
RFID Test can write data, read data, unlock, lock, deactivate and other operations on
RFID tags. This interface includes Write Data, Read Data, Access Password Setup, Read
Access Password, Kill Password Setup, Read Kill Password, Remove Tag sections.

1. Write Data

This section can to write of RFID data, operations should ensure that RFID module on
the RFID tag. Please refer to following figure 5.19:
53