Table of Contents
Advertisement
8. RFID data is written in BarTender
8.1 Writes Open Data in EPC Area
Method one: Write data in BarTender
Open Data can be written and read on the label without Access password. In this case,
RFID write is made on the label in ASCII format with the content "EXAMPLE ONE". By
BarTender, the steps are as follows
1. Open BarTender, select the
corresponding printer model, and
click the RFID icon in the upper view
bar to add the RFID label
1. Double-click the RFID tag with
the left mouse button to appear the
RFID data editing tag. In the RFID
option below the RFID Encoder, the
data type can be modified (Text or
Hex).
3. In the Data Source option, you can
edit the data to be written.
Data needs to be written according
to the RFID label type.
Data cannot be written outside the
storage scope of the RFID tag.
4.At this point, the Open Data
required to write is set, then only
need to edit the RFID tag surface
printed content. The visible content
and read data on the label are shown
on the right
Method Two: Write data in PrinterUtility
Can be set in Write Data Area in PrinterUtility RFID Test
plate
(Detailed explanation of the plate can be referred to in
Chapter 5 section
8). Enter the access password to be
72
Advertisement
Table of Contents
