Sokkia CX-52 Operator's Manual page 119

4. End topography observation
measurement.
After completing the observation,
pressing {ESC} displays the
completion confirmation message.
Press [YES] to record the
topography observation.
• When the collimation point is
registered, this message does
not appear.
PROCEDURE Topography RL Observation
1. Perform observation setting
following procedures 1~6 in the
"18.1 Observation Setting".
Set "YES" for "RL observation" in
the observation setting.
2. Measure the target point in the R
direction.
"R" appears next to the
"Topography observation
(Topography)"

"PROCEDURE Topography
Observation" step 2
3. Record the measured data.

"PROCEDURE Topography
Observation" step 3
4. Measure the target point in the L
direction.
"L" appears next to the
"Topography observation
(Topography)." Record the
measured data after the
observation is completed.

Steps 2 to 3
5. End the topography observation.

"PROCEDURE Topography
Observation" step 4
18. TOPOGRAPHY OBSERVATION
End Topography?
Topography
ZA 8 9
HA-R 0
HR
PT AUTO0011
EDM
Topography
ZA 2 7 0
HA-R 1 8 0
HR
PT AUTO0011
EDM
NO YES
R D=2
5 9 5 9
1 0 0 0
0.000m
ANGLE MEAS
L D=2
0 0 0 0
1 0 0 0
0.000m
ANGLE MEAS
111