Sokkia CX-52 Operator's Manual page 184

24. ROUTE SURVEYING
• The width pegs can be set up on both sides of the route and the left and right
route widths calculated separately.
• A point name is automatically assigned to peg No. that can be calculated. The
first part of the point name can be preset.
• The coordinates of calculated pegs are automatically stored in the current JOB.
When a particular point name already exists in the current job the available
option is possible to select whether or not to overwrite. It is possible to preset
which procedure is used in this situation.
PROCEDURE
1. In the second page of the OBS mode
screen, press [MENU], then select
"Road".
2. Select "Alignment" to enter the Route
Calculation menu.
3. Select "Auto calc." to enter the
automatic calculation of cardinal
points menu.
4. Set Sta incr (stationing increment),
middle P, CL ofs1 (centerline offset 1),
CL ofs2 (centerline offset 2), Existing
(procedure used when the same point
name already exists in the current
JOB), and Autoname (automatically
assigned suffix for point name).
176
A l i g n m e n t
D e f i n e e l e m e n t s
A u t o c a l c .
C a l c c o o r d
R o a d t o p o
S e t t i n g
A l i g n m e n t
S t a i n c r 1 0 0 . 0 0 0
m i d p i t c h
C L o f s 1
C L o f s 2
Add
E x i s t i n g P t
A u t o n a m e N o .
m
9 0 . 0 0 0 m
5 . 0 0 0 m
- 5 . 0 0 0 m
OK
OK