Sokkia CX-52 Operator's Manual page 100

16. SETTING-OUT ARC
3. Select "Define arc" in <Set-out
arc>.
• When [LOAD] is pressed,
registered coordinates can be
recalled and used.

"12.1 Entering Instrument
Station Data and Azimuth
Angle PROCEDURE Reading
in Registered Coordinate
Data"
4. Enter the arc From point data and
press [OK].
5. Press {}/{} to select
coordinates then press [OK].
To : Enter arc To point.
To/Center : Enter arc To point
To/Intersect : Enter arc To point
(intersection of the
Center : Enter arc Center
Intersect : Enter arc Intersect
Center/Intersect: Enter arc Center
6. Enter the coordinates specified in
step 5.
7. Press [OK] to proceed to arc
parameter input.
92
and Center point.
and Intersect point
tangents).
point.
point.
point and Intersect
point (intersection
of the tangents).
S e t - o u t a r c
S t n . O r i e n .
D e f i n e a r c
S e t - o u t a r c
F r o m P t .
LOAD REC MEAS
S e l e c t P t .
T o
To P t .
LOAD REC MEAS
C
OK
OK

OK