Table of Contents
Advertisement
32. WARNING AND ERROR MESSAGES
Pt already on route
Traverse tried to close on a traverse point other than the Start pt. during
automatic route search. Press any key to return to the last point found in
automatic route search. Either select the next traverse point to continue the
current search or specify the Start pt. to close a closed-loop traverse.
Please use the Star key in obs mode
Can be used only in the Observation mode.
Pt1-Pt2 too near
When setting the baseline with "Point to Line", two reference points are too
close.
Leave the space of 1 m or longer between the two reference points.
Same coordinates
The same values are input in Pt.1 and Pt.2 in setting-out line measurement.
CX cannot define the baseline.
SDR format err
The file read in is not SDR format. Check the file.
Send first
JOB data output (transmission to the host computer) is not completed before
JOB is cleared.
Either transmit the JOB to be cleared to the host computer.
Signal off
Measuring conditions are poor, and there is not any reflective light for
measuring distances.
Resight the target. When using reflective prisms, effectiveness will be
improved by increasing the number of prisms used.
Station coord is Null
Cannot calculate. Station point coordinate is set to "Null".
Input the coordinate.
Temp Range OUT
CX is outside useable temperature range and accurate measurement cannot
be performed. Repeat measurement within the appropriate temperature
range. If the CX is used under direct sunlight, use an umbrella to protect it
against the heat of the sun.
244
Advertisement
Table of Contents
