Sokkia CX-52 Operator's Manual page 71

8. Input coordinates for the first known
point and press [NEXT] to move to the
second point.
• When [LOAD] is pressed, registered
coordinates can be recalled and
used.

"12.1 Entering Instrument Station
Data and Azimuth Angle
PROCEDURE Reading in
Registered Coordinate Data"
• Press {ESC} to return to the
previous known point.
9. Repeat steps 4 to 8 in the same way
from the second point.
When the minimum quantity of
observation data required for the
calculation is present, [CALC] is
displayed.
Perform the following procedure
referring " 12.2.2 Coordinate
Resection Measurement" steps 8 to
12.

• Order of RL observation in resection measurement is as follows:
(1) 1st point (R1 → L1 → coordinates input)
(2) 2nd point (L2→ R2 → coordinates input)
(3) 1st point (R3 → L3 → coordinates input)
.
.
When re-observe the 1st point, the order is as follows:
(1) 1st point (R1 → L1 → press {ESC} to cancel the result)
(2) 1st point (L1 → R1 → coordinates input)
12. SETTING INSTRUMENT STATION
H R
LOAD REC
Resection
SD
ZA 8 0
HA-R 1 2 0
H R
LOAD REC
1st PT
2 0 . 0 0 0
3 0 . 0 0 0
4 0 . 0 0 0
1 0 . 0 0 0 m
NEXT
2nd L
3 0 1 0
1 0 0 0
ANGLE MEAS
3 r d PT
6 0 . 0 0 0
2 0 . 0 0 0
5 0 . 0 0 0
1 0 . 0 0 0 m
NEXT CALC
63