4. Ensure the Client for Microsoft Networks and Internet
Protocol (TCP/IP) are installed and checked. If NetBEUI is
installed, uninstall it.
5. Select Internet Protocol (TCP/IP) being careful not to
uncheck it, and then select Properties. See Figure 33.
Figure 33: Local Area Connection Properties
6. In the General tab, select Use the following IP address. Enter
an appropriate IP Address from the range of available IP
addresses.
7. Enter
255.255.255.0
8. Enter the terminal IP address as the Default Gateway.
Appendix B • Typical operating system settings
for the subnet mask.
1035978-0001 Revision A
57