If The Lan Led Dims - Hughes DIRECWAY DW7000 User Manual

If the LAN LED dims If the LAN LED goes dim, follow these steps:
1. Plug the Ethernet cable back into the Ethernet port.
2. Check the IP address assigned to the computer.
a. In Windows, go to
b. Type in the
command
Command window appears.
c. Type
ipconfig
Information related to the computer's network
configuration appears.
d. Check the IP Address
or to an address that begins with
0.0.0.0
sure the TCP/IP settings for your NIC are configured to
automatically obtain an IP address. Refer to Appendix B –
Typical operating system settings, on page 51.
If the TCP/IP settings are correct, power cycle the
computer; this sets the IP address correctly.
If the ipconfig command did not display IP address
information, there might be a problem with the NIC. Refer
to the manufacturer's documentation.
3. If the System Control Center is still not available, try pinging
the terminal by typing
command line and pressing E
If ping does not work, power cycle the terminal by
unplugging it from the power source, waiting 10 seconds, and
plugging it back in. If you still cannot ping, contact customer
support.
If the ping results show
cycle the unit.
You should now be able to access the System Control Center.
If you cannot, contact customer support.
→ Run . The Run box appears.
Start
field and click OK. The
Open
at the prompt and press E
field . If the IP address is set to
ping 192.168.0.1
.
NTER
request timed out
Chapter 4 • Troubleshooting
1035978-0001 Revision A
.
NTER
, make
169.254
at a DOS
, then power
41