Fatal Error Indication; Weather And Signal Strength; Led Appearance During Normal Operation; Remote Terminal Leds - Hughes DIRECWAY DW7000 User Manual

Fatal error indication

Weather and signal
strength
LED appearance during
normal operation
Chapter 3 • Remote terminal LEDs
24
1035978-0001 Revision A
If the Power LED is off and one or more of the other LEDs is
flashing, the unit may have to be replaced. Try power cycling the
terminal by unplugging the power cord from the power source
and then plugging it back in. The terminal may recover. If the
fatal error indication continues, the terminal must be replaced.
Contact customer support.
Rain or snow can interfere with signal strength. The terminal
stops receiving satellite signals, and the Receive LED turns off.
Heavy rain or snow can interfere with the antenna's reception of
the signal. In addition, buildup of moisture, snow, or ice on the
antenna can interfere with the signal. Similar conditions at the
NOC can interfere with signals for brief periods of time.
Severe weather conditions may interfere with signal reception.
Signal strength is restored as the rain or snow subsides.
This section describes the LEDs' appearance during typical
terminal operation. Refer to Figure 16 for LED locations.
Figure 16: Remote terminal LEDs