Reset Procedure - Smeg GW2145 User Manual

4.12 RESET PROCEDURE

The RESET procedure performs water pump-out and intake cycles to return the device to
conditions of safety in the event of a malfunction.
A RESET cycle can and should be started if an alarm occurs.
The Reset cycle can also be started independently, regardless of whether or not an alarm is
present.
N.B.: the RESET procedure can only be started with the door CLOSED.
When an error occurs, generally the device manages the anomaly itself: in this case the alarm
code flashes on the display until the problem has been dealt with: no reset commands are
accepted during this time.
Any RESET forced by the user will not be accepted until the problem has been dealt with and the
alarm code on the display is "steady".
If alarm "AF:84" (overheating during drying) occurs, the device manages its status independently
and does not allow a RESET to be performed until the automatic process for dealing with the alarm
has been completed.
STARTING A RESET
After an alarm or with the appliance at a standstill, press the Functions and Start/Stop buttons and hold them down
for about 2 seconds, until a beep is heard.
"P-" appears on the display and the RESET procedure starts.
At the end of the procedure, "E-" flashes on the display, alternating with the program which was running and has been
interrupted, if any.
Depending on the appliance's status, the RESET command may not be accepted: in this case, open and close the door
and then repeat the procedure.
ATTENTION
If it is not possible to perform the RESET cycle, before calling the After-Sales Service switch the
appliance off and back on and then try again.
fig. 24 – RESET cycle selection buttons: hold down the Start/Stop + Functions buttons together
User Manual GW2145 - GW1160 - GW4060 - GW4190 Page 36 - 86