Controls - Detailed Description - Smeg GW2145 User Manual

4.2

CONTROLS - DETAILED DESCRIPTION

BUTTONS
-
User Manual
DESCRIPTION
On/Off
The button is operational with the door opened or closed.
The button turns the device's interface on and off, allowing its use. Hold it down for 2
seconds for both switch-on and switch-off.
Once the appliance has been switched on, the code of the selected program appears on
the display (e.g. "Pr 03").
When the interface is switched off, the display shows a flashing "OFF" message.
When the door is open, the display shows 4 horizontal dashes and none of the other
interface buttons are active.
The device is still powered up even when the interface is off.
Drying +/- (only on GW4060, GW4190 series)
The buttons increase/decrease the intensity (and duration) of the drying phase.
Holding down the "Drying–" button selects a separate drying program; the display shows
the message "Pdry".
If the cycle set has a drying phase, these buttons are enabled and the drying LED
illuminates.
If the cycle set does not include a drying phase, the buttons are not enabled and the
drying LED remains off.
These are "first touch" buttons; there is no need to hold them down.
The drying duration set is displayed as follows:
- 3 horizontal bars on the display; maximum time setting, default time
- 2 horizontal bars, medium duration
- 1 horizontal bar, short duration
Start/Stop
This button starts the selected cycle or interrupts a cycle in progress. It must be held
down for 2 seconds.
Two beeps sound when a cycle is started or stopped.
The button is also used (again holding it down) to confirm the value of an appliance
parameter during modification.
Functions
Hold down: access to the appliance setup parameters, password required. Refer to the
SETUP MODE - "FUNCTIONS" section for a detailed explanation.
Short press: whenever the Functions button is pressed,
the display screen changes; the various screens show the parameters of the cycle
selected in combination with the LED which explains their meaning.
For a full understanding of the values shown on the display, note that they depend on the
appliance's status:
1. Appliance in standby
2. Washing cycle running
LED ON DISPLAY
1 : 16
-- : 90
GW2145 - GW1160 - GW4060 - GW4190
Meaning of LED on
With appliance in standby
The value is the nominal duration of the cycle. The time LED
also illuminates. The duration is guideline; it applies in test
conditions and with correct electrical connection.
With cycle running
Time left to end of current cycle
With appliance in standby
Maximum temperature reached in the cycle set
With cycle running
- During washing: Tank temperature
- During drying: Inlet air temperature
(function introduced from firmware version 4.6.xx.yy).
Page 18 - 86