Table of Contents
Advertisement
11.3 GW4190 SERIES
The appliance can be requested with top for built-in installation for special requirements.
In this case, the product is 30 mm shorter than the stated height.
N.B.: on the GW4190 series, the optional peristaltic pump P3 does not cause an increase in depth.
VERSION
STANDARD
STANDARD + ACQUASTOP
STANDARD + PAD1
STANDARD + P3
12 POSITIONING THE APPLIANCE
IMPORTANT
The appliance must be positioned with its back near a wall (with a gap of at least 10 mm) and must be installed by an
authorised SMEG engineer.
The installer engineer is responsible for the correct operation of the appliance after installation and must also
provide the user with all information required for its correct use.
During installation, the protective film must be removed from the steel outer surfaces.
The set of installation accessories (seals and hose ties) is inside the chamber.
The appliance can be installed with its sides flush against those of the adjacent cabinets, taking care not to obstruct
the steam vent on the rear. The wall at the back should be in masonry or another waterproof material.
Also take care that the heat does not reach any electrical circuits or sockets behind the appliance.
The appliance has water intake and drain hoses which can be positioned leading to the right or left, depending on
installation requirements.
If ordered in the appropriate version, the appliance can be installed built under a worktop; installation must be carried
out by skilled staff.
LEVELLING
After positioning the appliance, screw the feet down or unscrew them to adjust its height and level with the aid of a
spirit level so that it will be perfectly horizontal (max angle tolerance allowed: 0.5 °, corresponding to a maximum
permissible difference in height between opposite corners of the appliance of about 5 mm).
Correct levelling will ensure that the appliance operates correctly.
WARNING
Any adjustments, maintenance, etc. must be performed with the device switched off and disconnected from power
sources.
User Manual
A
B
600
600
600
600
710 / 750
600
600
600
GW2145 - GW1160 - GW4060 - GW4190
C
D
30
900
30
900
30
900
30
900
E
F
850
> 10
857
> 10
850
>10
850
> 10
Page 73 - 86
Hide quick links:
Advertisement
Table of Contents
