Manual Door Release Procedure; Gw4190 Opening The Door Of The Side Cabinet - Series Gw4190 Only - Smeg GW2145 User Manual

3.3

MANUAL DOOR RELEASE PROCEDURE

If necessary, due to a malfunction or power blackout, the appliance can be opened manually by releasing the lock
using a screwdriver with stem Ø4mm; be gentle, taking care not to damage the device.
1. This procedure is only possible with the appliance in standby status, with no cycle running.
2. Warning: before opening the appliance manually, disconnect it from the electricity supply.
3.
Insert a screwdriver or a rod 4 mm in diameter into the hole in the bottom of the centre of the front panel.
4. Push the pin upward until the lock is released.
3.4

GW4190 OPENING THE DOOR OF THE SIDE CABINET - SERIES GW4190 ONLY

GW4190 series models have a side cabinet with a hatch which opens like a drawer. Once the hatch is open, users have
full access to the components inside:

Main switch (circuit-breaker),

Panel printer (if installed),

Detergent cans.
To open the cabinet hatch, simply pull it towards you using the stainless steel handle provided.
The following are located above the panel that carries the master switch and printer:

RS232 port: for data transmission – connection by means of Smeg TRACELOG software.

"Data output" switch: used to activate the panel printer or data transmission on the RS232 port. These two
devices can never operate simultaneously. The data output switch activates the RS-232 port when turned to
"I" or the printer when turned to "II".
User Manual
fig. 6 – Diagram showing how to release the lock by hand in any emergency.
GW2145 - GW1160 - GW4060 - GW4190 Page 15 - 86