Resin Washing Phase; Resin Regeneration Phase; Programme Termination; In Progress Programme Interruption - Smeg WD1050 Operating Instructions Manual

6.5. RESIN WASHING PHASE

Message 'Lr' flashes on the display in alternation with the programme number during
the resin washing phase.

6.6. RESIN REGENERATION PHASE

Message 'r-' flashes on the display in alternation with the programme number during
the resin regeneration phase.

6.7. PROGRAMME TERMINATION

Message "EP" appears and flashes on the display once the programme has
terminated: therefore, the washing cycle must be considered terminated only when this
message appears. A "beep" signal begins to run and lasts for 5 seconds, after which
the door automatically opens.
WARNING
It may happen that it takes few seconds before the door opens; don't push the key
furtherly and, please, wait until it opens.
NOTE
At the end of a programme, once the door has been opened, we recommend to make
the drying of the instruments better by pulling the lower basket out of the washing
chamber and then by letting it stay over the door for a few minutes.

6.8. IN PROGRESS PROGRAMME INTERRUPTION

While a programme is running, you may stop it pressing the START/STOP button (4).
The following message appears on the display: "S1,..., S8", where the number
indicates the programme in progress.
If the interruption lasts longer than 1 minute, the machine will access an alarm status
and can only continue to operate after it has been RESET.

6.9. RESET PROCEDURE

In the event of an alarm or with the machine not responding to any keys, hold down
together the temperature "°C " (5) and the START key "► ll" (4) for few seconds till the
characteristic double beep sound is heard. Message 'P-' will appear on the display and
the RESET procedure will begin.
'E-' flashes on the display at the end of the RESET phase.
In some circumstances (e.g. when the washing chamber is hot) the RESET procedure
might not be accepted: in such a case open and close the door, then repeat the same
procedure (e.g. after few minutes).
NOTE: In any case, if the RESET procedure does not work, switch OFF and ON the
machine and try again before calling the Technical Assistance.
WD1050 12/04/2010 Pag. 20