Accessing The Setup Mode / Entering The Password - Smeg GW2145 User Manual

5.1

ACCESSING THE SETUP MODE / ENTERING THE PASSWORD

a. Hold the Functions button (5) down for 5 seconds. 4 dashes appear on the display.
b. Use the Selection buttons (4-8) to modify the individual characters of the password.
c. Short press the Functions button (5) to move on to the next character
d. Once the 4 characters of the password have been entered, confirm by holding down the Start/Stop button (3).
a. If the password entered is correct, the system accesses the first menu item
b. If the password is not correct, two beeps signal the error.
c. 5 seconds after the last button is pressed, the system automatically quits the Setup menu.
e. Once the Setup mode has been accessed, the various items available can be scrolled using the Functions button
(5).
f. Note on GW4060, GW4190 series: a short press on the button Drying + (6) has the same meaning of the short
press on button Functions (5) in the following cases:
a. When entering password, to switch from one character to the next.
b. Going into the setup mode, to scroll through the various items available.
The items accessible from the SETUP menu are shown in the table below. To move on from one item to the next,
press the "Drying" button.
Setup Item
Set
Cloc
Filt
Tec
Coun
PrEn
User Manual
fig. 27 – Functions button: hold down to access the Setup mode.
Description
Appliance parameter setup - detailed explanation provided below in "Set" Parameters
Date and time - detailed explanation provided below in "Cloc" Parameters
Drying filter counter. (Only for GW4060, GW4190 series)
Press the Start/Stop button to display the number of absolute filter hours left before the
maintenance message appears. The initial default setting is 500. The value is in units.
(Display only parameter, cannot be modified).
Appliance operating hour adds up towards maintenance. Press the Start/Stop button to
display the number of cycles left before the maintenance message appears. The initial
default setting is 900. The value is in units. (Display only parameter, cannot be modified).
Appliance total operation counter (display only parameter, cannot be modified)
Setting which allows display and selection only of the washing programs actually of
interest.
GW2145 - GW1160 - GW4060 - GW4190 Page 38 - 86