Table of Contents
Advertisement
Before removing the treated instruments, wait about ten minutes for the material inside the washing chamber
to cool and dry.
6.10. IN PROGRESS PROGRAMME INTERRUPTION
While a programme is running, you may stop it pressing the START/STOP button (4). The following
message appears on the display: "S1,..., S8", where the number indicates the programme in progress (e.g.
S7 stands for "forced stopping of programme 7).
If the interruption lasts longer than 1 minute, the machine issues an alarm: It is possible to continue only after
launching the RESET procedure.
6.11. RESET PROCEDURE
In the event of an alarm or with the machine not responding to any keys, hold down together the
TEMPERATURE (5) and the START key "► ll" (4) for few seconds till the characteristic double beep sound
is heard. Message 'P-' will appear on the display and the RESET procedure will begin.
'E-' flashes on the display at the end of the RESET phase.
In some circumstances (e.g. when the washing chamber is hot) the RESET procedure might not be
accepted: in such a case open and close the door, then repeat the same procedure (e.g. after few minutes).
NOTE:
In any case, if the RESET procedure does not work, switch OFF and ON the machine and
try again before calling the Technical Assistance.
6.12. DATE AND TIME SETUP
The machine is equipped with a real time clock system. This mainly serves for cycle tracing purposes (cycle
archive).
When needed, this clock system may be set up by means of the following procedure (available only when no
programme is running).
Press the ON/OFF button (3) to switch on the machine (If any alarm appears on the display at this
•
stage, ignore it).
Turn the programme selector knob (1) to position 8.
•
Press the Door Open button (6) for 4 seconds to enter the setup function The display begins to
•
flash.
It is possible to access and change the following parameters by using the programmes switch.
•
o
Position 1: YEAR [00-99]
o
Position 2: MONTH [01-12]
Position 3: DATE [01-XX] XX is calculated according to the month and year.
o
Position 4: hour [00-23]
o
o
Position 5: minutes [00-59]
o
Position 6: Seconds [00-59]
o
Position 7: inactive position – Display Flashing
o
Position 8: inactive position – Display Flashing
To increase a value press the TEMPERATURE button (5)
•
To decrease a value press START/PAUSE" (4)
•
To terminate, turn the programme selector knob (1) to position 8 and press the DOOR OPEN button
•
(6) for 4 seconds. The new DATE and TIME is now installed.
Rev. 00
GW2045 – GW1060 Manual
Pag. 28 di 43
Hide quick links:
Advertisement
Table of Contents
