End Of Cycle - Smeg GW2145 User Manual

4.9

END OF CYCLE

Once the selected program has been successfully completed, the display shows End".
"End" only appears if the washing phases have been performed and been completed correctly; it does not appear if
the program has been interrupted or if an error which may affect the cycles' effectiveness has occurred.
A "beep" sounds to indicate the end of the cycle.
AUTOMATIC OPENING AT END OF CYCLE
If automatic opening at the end of the cycle is enabled, the door of the Glassware Washer opens
automatically and only the 4 dashes appear on the display.
Automatic opening is not enabled if alarms occur during washing.
Drying LED: When a program which includes the drying phase is selected, at the end of the cycle, the
relative LED is:
1. on and steady if the process has been completed correctly,
2. flashing if drying has been interrupted (e.g. due to a power blackout or forced interruption of the
program by the user).
fig. 16 – End of cycle, display screen. The word End indicates that the washing process has been completed correctly. If automatic opening is enabled:
GW - AUTOMATIC OPENING AT END OF CYCLE
At the end of the cycle, the door can open automatically to allow the remaining steam to disperse and help the
processed material to cool and dry more quickly.
If the temperature inside the chamber is above 80°C, a delay of 10 minutes is automatically calculated before the door
opens.
During this delay, the lock can be released by pressing the Door opening button.
Automatic door opening at the end of the cycle is a parameter which can be enabled or disabled: refer to the
specific point: SETUP MODE - "FUNCTIONS".
Wait about 10 minutes with the door open before removing the processed load, to allow the material in the washing
chamber to cool, and if necessary to dry.
User Manual
the door is released automatically and the 4 dashes appear on the display.
GW2145 - GW1160 - GW4060 - GW4190 Page 31 - 86