Siemens LOGO! 24RC Manual page 58

Programming LOGO!
Editing a program
Switch LOGO! to programming mode
To do this, proceed as follows:
1. Switch LOGO! to programming mode:
( ,
2. Select "Program.." from the main menu
(by moving '>' to "Program.." and press OK)
3. Select "Edit Prg.." from the programming menu
(by moving '>' to "Edit Prg.." and press OK)
You can now modify the existing program.
Inserting an additional block in a program
Move the cursor to the B of B01 (B01 is the block number
of the OR block).
B01
At this point we insert the new block. Press OK.
BN
Select the SF list (
SF
Press OK.
50
and OK at the same time).
Q1
Q1
key).
Q1
Move the cursor:
Press
LOGO! displays the BN list.
The SF list contains the blocks
for the special functions.
LOGO! Manual
A5E00067781 01