Logo! Program Modules - Siemens LOGO! 24RC Manual

6 LOGO! Program Modules

You can only keep one program stored in LOGO!. If you
want to change the program or write another program with-
out deleting the first one, you must archive it somewhere.
You can use program modules/cards to do this.
You can copy the program stored in LOGO! to a program
module/card. You can insert the program module/card in a
different LOGO! and in this way copy the program to the
other LOGO!. You can use the program module/card to do
the following:
Archive programs
Duplicate programs
Send programs by post
Write and test programs in the office and then transfer
them to a different LOGO! in the cabinet.
LOGO! is supplied with a cover. You receive the program
module/card separately.
Note
You do not require a module for permanently storing the
program in your LOGO!.
The LOGO! program is already stored permanently when
programming mode is finished.
Below you will find the two modules that you can get for
LOGO!. Both of them can accommodate the entire pro-
gram memory of a LOGO!.
Yellow module: for copying
Red module: with know-how
protection and copy protection
LOGO! Manual
A5E00067781 01
Module Order number
6ED1 056-1BA00-0AA0
6ED1 056-4BA00-0AA0
137