Configure Other Parameters - HIKVISION DS-K3B961TX-L User Manual

Temperature Unit
Select the temperature unit that displayed in the device status.
4. Click OK.

8.7.2 Configure Other Parameters

After adding the access control device, you can set its parameters such as network parameters,
capture parameters, RS-485 parameters, Wiegand parameters, etc.
Set Parameters for Face Recognition Terminal
For face recognition terminal, you can set its parameters including face picture database, QR code
authentication, etc.
Steps
Note
This function should be supported by the device.
1. Enter the Access Control module.
2. On the navigation bar on the left, enter Advanced Function → More Parameters .
3. Select an access control device in the device list and click Face Recognition Terminal.
4. Set the parameters.
Note
These parameters displayed vary according to different device models.
COM
Select a COM port for configuration. COM1 refers to the RS-485 interface and COM2 refers to
the RS-232 interface.
Face Picture Database
select Deep Learning as the face picture database.
Authenticate by QR Code
If enabled, the device camera can scan the QR code to authenticate. By default, the function
is disabled.
Blocklist Authentication
If enabled, the device will compare the person who want to access with the persons in the
blocklist.
If matched (the person is in the blocklist), the access will be denied and the device will upload
an alarm to the client.
If mismatched (the person is not in the blocklist), the access will be granted.
DS-K3B961TX Series Swing Barrier User Manual
100