Note
For the card related functions(the type of access control card/multi-factor authentication), only
●
the card(s) with access group applied will be listed when adding cards.
The advanced functions should be supported by the device.
●
Hover the cursor on the Advanced Function, and then Click
●
function(s) to be displayed.
8.7.1 Configure Device Parameters
After adding the access control device, you can configure the parameters of access control device
(access controller), access control points (door or floor), alarm inputs, alarm outputs, card readers
and lane controller.
Configure Parameters for Access Control Device
After adding the access control device, you can configure its parameters, including overlaying user
information on picture, uploading pictures after capturing, saving captured pictures, etc.
Before You Start
Add access control device to the client.
Steps
1. Click Access Control → Advanced Function → Device Parameter .
Note
If you can not find Device Parameter in the Advanced Function list, hover the cursor on the
Advanced Function, and then Click
2. Select an access device to show its parameters on the right page.
3. Turn the switch to ON to enable the corresponding functions.
Note
The displayed parameters may vary for different access control devices.
●
Some of the following parameters are not listed in the Basic Information page, click More to
●
edit the parameters.
RS-485 Comm. Redundancy
You should enable this function if you wire the RS-485 card reader to the access control
device redundantly.
Display Detected Face
Display face picture when authenticating.
Display Card Number
DS-K3B961TX Series Swing Barrier User Manual
to select the Device Parameter to be displayed.
93
to customize the advanced