Table of Contents
Advertisement
Adding FRU information
When you replace a FRU details are not recorded in the VPD. You must enter them
manually through SMS.
When the system firmware detects an FRU replacement part during boot the
process stops to allow you to enter the machine type or model and serial number.
Boot does not continue until the information is provided.
To enter new FRU information, complete the following steps:
1. Using a Telnet or SSH client, connect to the Advanced Management Module
2. When prompted, enter a valid user ID and password. The default management
3. Power cycle the blade and start an SOL console by using the power -cycle -c
4. The following screen appears:
78
BladeCenter QS22 Type 0793: Installation and User's Guide
PowerPC Firmware
Version QD0123000
SLOF-SMS 1.1 (c) Copyright IBM Corp. 2007 All rights reserved.
--------------------------------------------------------------------------------
FRU Information
Machine Type and Model: 079338x
Machine Serial Number: ABCDEFG
Universal Unique ID: 12345678-1234-1234-1234-123456789ABC
--------------------------------------------------------------------------------
Navigation Keys:
M = return to Main Menu
ESC key = return to previous screen
--------------------------------------------------------------------------------
Select Navigation key :
external Ethernet interface IP address.
module user ID is USERID, and the default password is PASSW0RD, where the
0 is a zero.
Note: The userid and password may have been changed. If so, check with the
system administrator for a valid user id and password.
command. See "Using the SMS utility program" on page 41 for further
information.
X = eXit System Management Services
Advertisement
Table of Contents
