Table of Contents
Advertisement
Figure 11. Removing the front bezel assembly
Complete the following steps to remove the front bezel assembly:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. If applicable, shut down the operating system, turn off the blade server, and
3. Open the blade server cover. See "Opening and removing the blade server
4. Carefully disconnect the control panel cable from the control panel connector
5. Press the front bezel release on both sides of the system board and pull the
6. Store the front bezel assembly in a safe place.
Installing the optional modular flash drive
The modular flash drive connects to the flash drive connector on the system board
and provides non-volatile memory. This may be used, for example, for installing an
operating system.
Complete the following steps to install the modular flash drive:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. If applicable, shut down the operating system, turn off the blade server, and
3. Open the blade server cover. See "Opening and removing the blade server
24
BladeCenter QS22 Type 0793: Installation and User's Guide
Blade cover
Cover release
Bezel release
on page 19.
remove the blade server from the BladeCenter unit. See "Removing the blade
server from the BladeCenter unit" on page 20.
cover" on page 21.
(see Figure 11).
front bezel assembly away from the blade server.
on page 19.
remove the blade server from the BladeCenter unit. See "Removing the blade
server from the BladeCenter unit" on page 20.
cover" on page 21.
Cover release
Bezel release
Control-Panel
Cable
Bezel assembly
Control-Panel
Connector
Advertisement
Table of Contents
