Intermec Sabre 1555 Programmer's Reference Manual page 120

Sabre 1555 RFID & Bar Code Reader Programmer's Reference Manual
Table 4-38 Configuration Utility Commands (continued)
Reset Factory Defaults
Command Name
Reset all parameters to their default settings.
Description
None
Parameters
ACC (command accepted)
Responses
NAC (command not recognized)
Product Hardware Reset
Command Name
This command restarts the product. Simulates cycling power. Product uses
Description configuration parameters stored in NVM. If in temporary configuration, settings are set
from those in NVM.
None
Parameters
ACC (command accepted)
Responses
NAC (command not recognized)
Get Version Info
Command Name
Software version
Description
None
Parameters
ACC (command accepted)
Responses
NAC (command not recognized)
Display Data String Mode
Command Name
Displays ASCII equivalents of data string and checksum values on a terminal screen
Description when you read configuration bar codes without implementing configuration bar code
settings. Remains active until the product is switched off or a PRC (\3F) is issued.
None
Parameters
ACC (command accepted)
Responses
NAC (command not recognized)
Configuration Enable
Command Name
Configuration possible all the time (default mode)
Description
None
Parameters
ACC (command accepted)
Responses
NAC (command not recognized)
4-80
<TYPE> <CMD>: \0D\46\42
<TYPE> <CMD>: \0D\4C\41
<TYPE> <CMD>: \0D\46\43
<TYPE> <CMD>: \0D\46\4E
<TYPE> <CMD>: \0D\46\50