UniCarriers FRSB14-8 Operation & Maintenance Manual page 71

Do not Do not use the laser use the laser
• •
be subject to water splashes or condensation be subject to water splashes or condensation
will occur. will occur.
Do not use Do not use t
• •
laser beam might cause equipment around it to laser beam might cause equipment around it to
malfunction. malfunction.
• •
The fork The fork
to improve work efficiency, especially when to improve work efficiency, especially when
retrieving loads from an elevated position. The retrieving loads from an elevated position. The
operator is required to check the fork position operator is required to check the fork position
by direct observation as well as by looking at by direct observation as well as by looking at
the instrument panel. the instrument panel.
The fork positioning laser The fork positioning laser u
• •
used while the truck is on a flat surface. The used while the truck is on a flat surface. The
fork position cannot be correctly monitored on fork position cannot be correctly monitored on
an inclined surface. an inclined surface.
INSTALLING THE FORK POSITIONING INST ALLING THE FORK POSITIONING
Install the laser unit [2] so that the laser beam source Install the laser unit [2] so that the laser beam source
• •
is 30 mm above the surface of the forks [3]. is 30 mm above the surface of the forks [3].
Adjust Adjust the the
• •
only emitted when the forks are level. only emitted when the forks are level.
CAUTION CAUTION
The installation and adjustment of the laser unit The installation and adjustment of the laser unit
requires a high level of skill. Leave it to your local requires a high level of skill. Leave it to your local
UniCarriers dealer. UniCarriers dealer.
INSTRUMENTS AND CONTROLS INSTRUMENTS AND CONTROLS
unit in a unit in a place where it place where it
the laser unit in a place wh he laser unit in a place
positio positio ning laser unit ning laser unit
unit should only be nit should only be
limit limit switch switch [1] [1] so so that that the the
https://www.forkliftpdfmanuals.com/
will will
where the ere the
is intended is intended
Max. A:B Max. A:B
Min. A:B Min. A:B
C C = =
A: Distance A: Distance
LASER UNIT LASER UNIT
laser laser beam beam is is
(Detail of area "A") (Detail of area "A")
1. 1. Limit Limit
2. 2. Laser Laser
2-27 2-27
Laser beam width Laser beam width
20 – 42° 20 – 42°
≒ ≒
1:0.8 1:0.8
≒ ≒
1:0.35 1:0.35
The beam is less than 2 The beam is less than 2 m mm wide at a distance m wide at a distance
of 5 m or less of 5 m or less
B: Beam length B: Beam length
A A
2 2 3 3
30 mm 30 mm
switch switch 3. Fork 3. Fork
marker marker
C: Beam width C: Beam width
1 1