Table of Contents
Advertisement
2.2
Connecting Hardware
2.2.1
DIN Rail Mounting
The DIN rail mount option is the quickest installation option. Additionally, it optimizes
the use of rail space.
The metal DIN rail kit is secured to the rear of the gateway. The device can be
mounted onto a standard 35 mm (1.37") x 7.5 mm (0.3") height DIN rail. The devices
can be mounted vertically or horizontally. Refer to the following guidelines for further
information.
Note!
A corrosion-free mounting rail is advisable.
When installing, make sure to allow for enough space to properly install
the cabling.
2.2.1.1
Installing the DIN-Rail Mounting Kit
1.
Position the rear panel of the gateway directly in front of the DIN rail, making
sure that the top of the DIN rail clip hooks over the top of the DIN rail, as shown
in the following illustration.
Warning! Do not install the DIN rail under or in front of the spring mechanism on
the DIN rail clip to prevent damage to the DIN rail clip or the DIN rail.
Make sure the DIN rail is inserted behind the spring mechanism.
2.
Once the DIN rail is seated correctly in the DIN rail clip, press the front of the
gateway to rotate the gateway down and into the release tab on the DIN rail clip.
If seated correctly, the bottom of the DIN rail should be fully inserted in the
release tab.
EKI-6233BN User Manual
Figure 2.5 Installing the DIN-Rail Mounting Kit
9
DIN rail clip
DIN rail
DIN rail clip
release tab
Advertisement
Table of Contents
