Table of Contents
Advertisement
2.2
Installation Procedures
2.2.1
Connecting the Power Cord
The POC-S176 could only be powered by a DC power adapter (SINPRO Model No.
MPU100-107). Be sure to always handle the power cords by holding the plug ends
only.
Follow these procedures in order:
1.
Connect the female end of the power adapter to the DC jack of the panel PC.
(See Figure 2.3.)
2.
Connect the female end of the power cord to the DC power adapter.
3.
Connect the 3-pin male plug of the power cord to an electrical outlet.
Warning! The POC-S176 is supplied by a 100 Watt power supply and a special
adapter as depicted in the model above.
If a medical adaptor is connected to the POC-S176, the customer must
ensure legal and regulatory compliance and that the device meets the
law and standards compliance requirements of this hardware.
2.2.2
Switching on the Power
Switch on the power switch on the back I/O.
Figure 2.3 Connecting the power cord
9
POC-S176 User Manual
Advertisement
Table of Contents
