Table of Contents
Advertisement
2.2.2
Wall-Mounting
The wall mounting option provides better shock and vibration resistance than the DIN
rail vertical mount.
Note!
When installing, make sure to allow for enough space to properly install
the cabling.
Before the device can be mounted on a wall, you will need to remove the DIN rail
plate.
1.
Rotate the device to view the rear side and locate the DIN mounting plate.
2.
Remove the screws securing the DIN mounting plate to the rear side.
3.
Remove the DIN mounting plate. Store the DIN mounting plate and provided
screws for later use.
4.
Align the wall mounting bracket with the designated location on the device as
illustrated in the following figure. The screw holes on the device and the
brackets align if seated correctly.
5.
Secure the wall brackets to the device with M3 screws, see the following figure.
Once the wall mounting brackets are secured on the device, mark the screw
hole location on the wall area.
6.
On the installation site, place the device firmly against the wall. Make sure the
gateway is vertically and horizontally level.
7.
Insert a pencil or pen through the screw holes on the mounting bracket to mark
the location of the screw holes on the wall.
8.
Remove the gateway from the wall and drill holes over each marked location (4)
on the wall, keeping in mind that the holes must accommodate wall sinks in
addition to the screws.
9.
Insert the wall sinks into the walls.
10.
Align the mounting bracket over the screw holes on the wall.
EKI-6233BN User Manual
Figure 2.8 Installing Wall Mount Plates
11
Advertisement
Table of Contents
