Paper Cutter General Information; Controlling The Cutter; Technical Manual - Intermec EasyCoder 201 II Technical Manual

Intermec EasyCoder 201 II – Technical Manual
PAPER CUTTER
General Information
CAUTION!
The cutting edge will rotate when
the power is turned on and when
the printer is rebooted.
Always keep the cutter unit in
closed position during operation.

Controlling the Cutter

The paper cutter is intended to cut through continuous paper strip
or through the backing paper between labels. It uses a rotating edge.
The cutter must not be used to cut through any kind of adhesive,
which would stick to the cutting parts and rapidly render the cutter
inoperable – possibly also causing damage to the electric motor.
When self-adhesive labels are used, be careful only to cut in the gaps
between labels. Obviously, self-adhesive paper strip cannot be
used.
Maximum paper thickness is 175 m ( 175 grammes/m
normal paper-based materials.
A paper cutter fitted on an EasyCoder 201 IIE.
In EasyCoder 201 IIS and EasyCoder 201 IIE printers , the cutter
is activated by
CUT
Fingerprint Reference Manual or the Intermec Direct Protocol
Programmer's Guide.
In EasyCoder 201 IISA, the cutter can be turned on or off by means
of a menu in the Set Mode, see the Intermec Stand-Alone Concept;
Operating Instructions.
or instructions, see the Intermec
CUT ON
2
) for
62