Setup Mode Overview, Part 1; Technical Manual - Intermec EasyCoder 201 II Technical Manual

Intermec EasyCoder 201 II – Technical Manual
SETTING UP EASYCODER 201 IIE & 201 IISA, cont'd.

Setup Mode Overview, Part 1

SETUP: min CONTRAST max
CONTRAST
SETUP: SER-COM:
SER-COM UART1
UART2
UART3
If an optional interface board
with at least one serial channel
is fitted, communication setup
menus for each of the channels
will be displayed.
SETUP: DETECTION:
DETECTION LSS ADJUST
DETECTION:
FEEDADJ
• Press Enter to enter the Service part (see next page).
SETUP:
• Press F5/–> to go back to the "Setup; Contrast" menu.
SERVICE
• Press Setup/Save to exit the Setup Mode.
• Press F4/<– key to decrease 1 step
• Press F5/–> key to increase 1 step
SER-COM: BAUDRATE:
BAUDRATE 9600
19200
38400
300
600
1200
SER-COM: PARITY:
PARITY NONE
EVEN
ODD
MARK
SPACE
SER-COM: CHAR LENGTH:
CHAR LENGTH 7
8
SER-COM: STOP BITS:
STOP BITS 2
1
SER-COM: FLOWCONTROL:
FLOWCONTROL RTS/CTS
FLOWCONTROL:
ENQ/ACK
FLOWCONTROL:
XON/XOFF
FLOWCONTROL:
PROT ADDR
SER-COM: NEW LINE:
NEW LINE CR/LF
LF
E n t e r CR
LABEL <> GAP
FEEDADJ: STARTADJ:
STARTADJ [0]:
FEEDADJ: STOPADJ:
STOPADJ [0]:
E n t e r
LEGEND:
Boxes with thick lines indicate default setup
Boxes with dotted lines indicate menus related to
optional interface boards.
Baudrate 38,400 is only
available on "uart2:" and "uart3:"
2400
4800
RTS/CTS:
DISABLE
ENABLE
ENQ/ACK:
DISABLE
ENABLE
XON/XOFF:
DATA FROM HOST
XON/XOFF:
DATA TO HOST
PROT ADDR:
DISABLE
ENABLE
• Press F1/Ins key to view current value
• Press F4/<– key to decrease value 1 step
• Press F5/–> key to increase value 1 step
• Press Feed key to autoadjust the LSS and feed out 1 label.
Not for RS422/485
on "uart2:"
DATA FROM HOST:
ENABLE
DISABLE
DATA TO HOST:
ENABLE
DISABLE
Only for RS422/485
on "uart2:"
35